NASA Moves Closer to Building a 3-D Printed Rocket Engine
nasa.gov
nasa.gov
Here's Space-X's 3D printed engine.[1] Watch the video of the test firing. The engine is being throttled up and down, at higher and higher rates. Those guys like aggressive control strategies, as seen with the Falcon booster landing, and an engine which can keep up helps.
[1] http://www.spaceflightinsider.com/organizations/space-explor...
So, you're technically correct: generally, they are on the same scale. And your argument about ignitability is certainly true.
1. http://www.quakerchem.com/wp-content/uploads/pdf/skill_build...
"3-D printing" should be used when referring to hobbyists making semi-useless, plastic trinkets. No disrespect to plastics or hobbyists, it's just that the phrase lost some dignity when it became a over-generalizing buzzword.
This method is quite different from the "ordinary" metallic vapour deposition process you're referring to that uses a simple fixed-position mask, usually photoresist that is baked right onto the silicon wafer.
Eg, here is my research paper from 8 yrs ago demonstrating nanoscale-level dynamic stencil deposition using a nanopore in a suspended silicon nitride membrane shadow mask. We controlled the mask's position using a piezo actuator inside the deposition chamber during the evaporation process to 3D print nanowires and other nanostructures with programmable height profiles. Eg, we created nanoramps, and nanowires with one or more "valleys" to simulate quantum wells or metallic grains. http://scitation.aip.org/content/aip/journal/rsi/79/7/10.106... Arxiv link : http://arxiv.org/pdf/0802.1848.pdf
He felt calling those "toys" computers was some disrespectful for the real thing, the one with 125 MBytes hard drive, instead of the ridiculous amount the toys had at the time.
Of course he wanted all the company to buy an IBM mainframe(under his control of course). My father decided to buy 30 micro computers instead. It was a great decision st the end.
Those hobbyists making semi-useless, plastic trinkets are the same people that will make the serious low tolerance manufacturing in the future.
Did you learned to run and jump before crawling?
Piping can be printed, but given the stresses at attachment points, I cannot see that printing pipes would save many man-hours.
The turbopump casings could certainly be printed, but not in "one piece". Someone needs them open to insert the bearings and blades. So two pieces at best ... exactly as if they had been milled rather than built additively.
So what's left? The combustion chamber and bell might do well. They have some internal voids/plumbing that probably suits such printing. But the stresses?
The physics of ISP is well-understood and current engines are near what is physically possible, regardless of who/what builds the engines. 3d printing could certainly make engines more affordable and/or lighter, but it isn't going to allow an engine to be any more fuel efficient.
Anyone who builds an engine with significantly increased ISP using standard fuels (ie without going nuclear) will probably win a few nobel prizes. 3d printing is about improved manufacturing, not new physics.
[1] http://www.spacex.com/press/2014/05/27/spacex-completes-qual...
Can we rename Christmas to Christmusk and change the date to the 21st?