If you look at mainboards (or some smaller PCBs), the connecting lanes between e.g. RAM and CPU closer to the centre are often zigzagged, to match the lengths – and delays – of the necessarily longer outer lanes. The speed of light is actually really damn slow.
I don't think one really appreciates that until they found out that after X hours of place&route they missed timing by some fraction of a nanosecond
It's say it's the opposite, really. The longer the wires, the more effort it takes to synchronize their delays within a certain number of picoseconds.
You've got plenty of stuff at the test stage too. E.g., the gear on high-end Lecroy's metrology test gear is at 100ghz. Agilent (Keysight, whatever, it's still HP to me) has a full test rig for USB3.1[0] at 10gbps for their consumer level gear (again, fairly slow). Step it up to FPGA speeds and here's[1] an app-note by Altera with way higher speeds.
Here's a really brief overview of 'rules of thumb' that work up to PCI-e[2] by TI. 50 minutes and worth a watch. Clean power that won't couple in, matching lines lengths on diff pairs, proper isolated ground planes (give AGND and DGND their own layers) and proper termination will easily get you 95% of the way there.
(Shameless promotion-- available for high-speed design, pre-EMC compliance testing, fault diagnostics, etc).
[0] http://www.keysight.com/en/pd-2472798-pn-U7243B/usb-31-compl... [1] https://www.altera.com/en_US/pdfs/literature/an/an528.pdf [2] https://www.youtube.com/watch?v=A3qw_Ecx9Co