* You're developing a controller that controls something. Now you have to have the hardware it controls. This can be a sizable piece of industrial equipment. You may need a simulator for it.
* I've seen auto engine controls developed. Phase I was run connected to an engine simulator. Phase 2 was run connected to a test board with the auto components, including one spark plug, and an analog computer to simulate the vehicle power train. Phase 3 was run on a test stand with a real engine. Phase 4 was run in a car with a debug system plugged in. Yes, you need all that stuff.
* Safety issues. You may need a separate safety system to monitor the primary system and shut it down. Traffic lights have a simple hard-wired device which has inputs from all the green lamps, and a PC board wired with diodes to indicate which can't be on at the same time. If the checker detects a conflict, a relay trips, all the lights go to flashing red, and the CPU can't do anything about it. Some systems allow the CPU to try again after 30 seconds of flashing red, but usually it requires someone to come out and replace the electronics.
* JTAG is your friend, but JTAG is so low-level that it's a huge pain.