It's a harder problem than it seems, as I've found out over the past 6 years. While the basics are quite similar to a 3D printer, PnP has some unique challenges. 3D printing can be relatively inaccurate but still produce a good output since you are working with a pretty "oozy" substance to begin with. PnP has to be pretty accurate across it's entire work surface, though. If the machine is 0.1mm off at any point in it's travel that creates a likelihood that a part will be placed incorrectly. Feeders are also, mechanically, a lot more difficult to get right than it seems like they would be.
In any case, we're having good luck and a lot of success, so if you are interested in DIY / Open Source / Hobby pick and place, please come check it out!