Don't do that. You risk legionnaires disease. Set the temperature to at least 140F.
I have a tankless water heater, though. The water won't be at 140F for very long, so I can't imagine it actually killing very much bacteria.
How does water heater temperature below 140F increase the risk of getting legionnaires disease?
Also, I always wash my clothes on warm, never on hot, because I don't want my clothes to shrink.
Many clothes manufacturers also label the clothes they make with directions saying to only wash on warm or cold. Otherwise, presumably, the clothes might get damaged.
At 140F or above it's killed. Around 100F it thrives. It's one of the rare bacteria that do well in hot water, and is naturally found in our water supply (as opposed to exotic locales).
120F is the max recommended hot water temperature in the International Plumbing Code.
And not at the dishwasher or washing machine.
> Far more people get scalded by tap/shower water that is too hot than contract legionnaires by several orders of magnitude.
First of all virtually no one actually sets their tank at 120F.
Second:
"It is estimated that Legionnaires' disease is the cause of between two and nine percent of pneumonia cases that are acquired outside of hospital." [1]
"There are an estimated 8,000 to 18,000 cases a year in the United States that require hospitalization for legionnaires" [1]
"11,028 scald burns in children younger than 3 years old annually." [2]
"8,620 visits per year among Adults Aged ≥65 Years" [3]
I don't have numbers for the full population, but your "several orders of magnitude" is clearly quite off. At best it's a single order of magnitude - and that's only because almost no one actually sets the temperature so low.
If they did the number would swing.
And don't forget the pneumonia rates. This is not some rare unheard of disease.
[1] doi:10.1016/s0140-6736(15)60078-2.
[2] https://www.researchgate.net/publication/276065254_Scald_bur...
Your machine has longer and shorter programs, my 60C wash takes about 3 hours by default while a quick was is obviously considerably faster.
If you pull hot water from the heater and circulate it around for 30 min, it's not going to be that hot at the end of the cycle.
But that said, it would not be hard to run 240V to washer, so that can't be the reason.
Do Europeans typically heat water with electricity? That might be the reason - if you are anyway using electricity, you might as well let the washer do it.
In the US natural gas water heaters are very common (it's more efficient). And natural gas dryers too.
Modern front-loading washing machines, especially those managing an A or better on the EC's energy rating system, tend to use very little water, though. Depending on the plumbing system, by the time the potential cold water in the hot water pipes had run through, you might not get very much hot water at all before you were done, so you'd have to heat electrically anyway.