Very far from a floating point expert here, but what I do is to scale-down by a few odd prime-power factors as appropriate:
Scaling down by powers of 5 is obviously appropriate for decimals, currency etc.
Scaling down by powers of 3 is good for angles measured in the degrees, minutes, seconds system.
If one scales down a lot there is an increased risk of overflow, so one can compensate by scaling up some powers of 2.
The way I think of this is as using my own manual exponent bias [0].
>the exponent is stored in the range 1 .. 254 (0 and 255 have special meanings), and is interpreted by subtracting the bias for an 8-bit exponent (127) to get an exponent value in the range −126 .. +127.
So, for example, even single-precision number are always exact multiples of 1/(2^126), and I'm just changing the denominator to contain powers of 3, 5, 7, ... etc.