Cast iron, seasoned, is supposed to be slicker than non stick. You should be able to fry an egg in it.
With lodge you have to build up that non stick over the sand casting “bumpies” that are left over from the iron casting process.
They used to machine those out, especially on the cook surface. Until this latest crop of modern cast iron manufacturers, one would typically have to retreat to vintage or perhaps machine your own.
I think most people just look at the sorry state of “lodge” then grab a pfa laden non stick and go home.
>All non-stick coatings contain PTFE, the abbreviation for polytetrafluorethylene, a plastic polymer. It is a slippery ingredient, made up of molecules of tetra fluoro ethylene that only contain carbon and fluorine.
Tefal/T-fal have been one of the main proponents and suppliers of teflon cookware (hence their name), switching formulas every so often, once the toxicity of the various generations of coating have become an issue.
The key things I'm going to highly highly highly recommend are a good filter mask, good ventilation (or excellent ventilation and a big shop fan blowing past if you have a beard) and a way to securely hold the piece you're working on. I don't have a link, but I like what one guy put together with a heavy duty board - a hook at one end through a hole, and a hook at the other through a slot that could be adjusted to fit the piece. Don't tighten down hard at all unless you want to risk breaking things, just enough to keep what you're working on from shifting around as you sand.
Alternatively you can put it into oven and bake it at that temperature.
Goal is to keep it below smoking point.
It works to reseason the pan after minor damage (not yet rusted, but lacking non-sticky surface). I use the pan almost every day, so I don't have experience with fixing heavier damage.
If the pan gets sticky to the finger afterwards (it shouldn't if you avoid poodles of oil), don't worry. It will resolve itself after a few cooking cycles.
If you want to go bare-metal and have an oven with a self-cleaning cycle, that's probably the simplest way to go - put the cast iron in there open-side down and run that cycle. I'm not sure just how much smoke this will release, but you might not want to do it on a day when you can't open windows. I've also seen notes that this can sometimes cause warping, so buyer beware.
To build up the seasoning, it's basically going to be multiple repetitions of putting on a thin layer of a high-smoke-point food-safe oil, heating and repeating. Darker color generally just indicates more layers.
In some ways it's almost like you're varnishing the cookware with an oil-based varnish, but without some of the other components of varnish. A lot of guides will recommend flaxseed oil for seasoning, it's also known as linseed oil and used to be pretty common in varnishes and wood finishes. For a contrary (and easier and cheaper) view, see https://www.reddit.com/r/castiron/comments/5owtnm/why_i_dont...
(see also https://en.wikipedia.org/wiki/Drying_oil about oil-based varnishes)
They're also all machined to a smooth finish after molding, where the Lodges are cleaned, possibly sanded a bit to get rid of any lingering material from the mold, then seasoned. Part of the reasoning I've heard for the rougher finish on Lodge pans is that it makes that initial factory seasoning much easier to get on there. If you look around in the cast iron arena you'll come across a fair amount of information on how to do your own machining at home with drills, abrasive pads, hand sanders, etc.
Beyond that, some of them have different configurations of spouts, secondary handles, etc. - they're all somewhat different.