I was about to suggest the idea of using gears like from a vehicle's transmission (i.e. first gear is easy to turn, will shift to larger when certain condition achieved), but it sounds like these ideas have been hashed out already.
I was about to suggest the idea of using gears like from a vehicle's transmission (i.e. first gear is easy to turn, will shift to larger when certain condition achieved), but it sounds like these ideas have been hashed out already.
Put it into a high gear in a high wind, it may not rotate fast and fly off due to angular momentum, but it might just snap off.
The surprising result of this is that the brake force needed to keep the turbine stopped is much smaller than the one needed to stop it, despite the relatively low mass of the blades.
AKA
wind speed hours/year
0-10 4000
10-15 2700
15-20 1100
25-30 600
35-40 300
40-50 50
50-55 15
At some point the cost analysis says the extra power generated isn't worth the cost of the oversize generator needed to extract it so just feather the turbine.If you're local "average wind speed" is 5m/s (~12mph, a "Gentle Breeze" and #3 on the Beaufort scale), and you size your wind turbine to generate useful power (say, 1000W, for example) at that speed, you have two consequences due to that speed-cubed term.
1) When there's only light wind - say half your design average speed, you're only gonna get 1/8th of your 1000W target, so only 125W which isn't very useful if you've got a 1000W requirement.
2) The _bigger_ problem is when the wind blows faster than average. If you get twice average speeds, your turbine is going to generate 8kW which you'll need to safely deal with. But twice isn't your problem - in the real world it's not uncommon for 3 or 4 times average windspeed (what we'd normally just call "a windy day" and 7 or 8 on the Beaufort scale), at which stage you're going to need to safely dump 64kW of power - if your turbine hasn't been braked/parks appropriately (or torn itself to pieces.) If you're still spinning in hurricane conditions, you've got another doubling of windspeed, and another eightfold increase in power, so now your "1000W generator" is unleashing half a megawatt into your wiring and control electronics (or the plasma in the smoke where your wiring used to be...)
Beaufort scale with speeds and descriptions: https://en.wikipedia.org/wiki/Beaufort_scale#Modern_scale
Some real world windspeed measurements showing upper end outliers of 8 times average speed: http://www.wind-power-program.com/wind_statistics.htm
The other problem is adding the mechanical complexity all up in the nacelle of the wind turbine, where it is hard to service and maintain.