On the CoCo 3 you didn't have to hit reset; there was a way to switch it in software.
Also on the CoCo 3, there was the 640 x 192 4-color "hires" mode. Way, way back - I believe published in Hot CoCo - someone figured out that using a television, and setting those 4 colors to the grayscale in the 64 color palette (black, dark grey, light grey, and white) - and with proper 4-bit pixel settings, you could get a virtual 128x192 image with colors.
Basically the same technique (called artifact colors, or artifacting) - but applied to the high-res screen of the CoCo 3.
Unfortunately - he sent it to Hot CoCo! Had he sent it to the Rainbow instead...things might have been different. You see, by sending it to that magazine, it didn't reach a large audience, so only a few people saw it, nobody much played with it, and it faded into history.
On the Rainbow side of things, there were a couple of articles about using patterns of color to create "virtual colors" - but it was geared toward the RGB monitor (CM-8), and not really the TV - and using colors, not the gray scales...
So - what am rambling about then?
Well - long story short - this:
http://richg42.blogspot.com/2014/02/the-little-known-color-c...
A virtually unknown "256 color" mode on the Color Computer 3 that was lost to history.
Now - this isn't the mystery 256 color mode that has been described elsewhere hiding in the GIME chip (and most people believe that it is a false rumor; but the Microware CoCo 3 prototype holds out hope) - but it is a working "hi color" mode available on the CoCo 3.
Unfortunately, today, it is only a curiosity more than anything, and it is unknown whether it could have been used back then; from what I recall, they had to use a PC to figure out the proper bit patterns for each of the colors, and that kind of processing would have been difficult at best back then.
EDIT: This really shows off what is possible with the mode:
http://atariage.com/forums/blog/105/entry-6693-color-compute...