Good caps are expensive, and cheap alternatives are plentiful. Nine out of ten off the shelf LED drivers have cheap ass chinese caps in them.
You also need good overall thermal design, which means good heatsinks, which means chunks of metal, which of course are expensive.
It's entirely possible to make a driver that will outlive any LED it powers, it's just that nobody wants to pay for it.
I dunno about the shoes but Snap On isn't really great quality anymore. The Chinese have closed the gap. Fluke, Honda and to a greater extent Toyota are all steadily moving toward more disposable products.
The cheap Chinese kitchen stuff you mentioned is actually the most durable item because in order to stand up to occasional abuse without being damaged it needs to be so overbuild that it can last lifetimes. That's simply a function of the design requirements, not any particular manufacturer's attitude though.
You raise a good point though. Its very hard to evaluate a product that's supposed to last a life time, until you've had it a lifetime. So the benefits to a manufacturer are slow to accrue, but they're also slow to dispel, so there's massive temptation to cut corners and rely on that reputation, while lowering costs.
It'll be interesting to see how the EV market works out. You have a product that could last for life (with battery replacements). I suspect they'll be viewed, by the manufacturer at least, as disposable when the battery goes.
Not sure what availability is like in the US and other countries though.
Edit: Sometimes LED current is actually high-current AC with a square waveform, especially with dimmable bulbs. This is fine provided it's well-regulated and protected from spikes.
LED tolerance doesn't really play into the scenario here. It's all about the driver.
As a result you generally need to wire them in series rather than in parallel so that the current can’t differentially select the LED of least resistance and cause thermal runaway. Series wiring in turn cranks up the voltage requirements necessary to drive lots of power, requiring more costly components.
Oh, forgot to mention, different color LEDs have different forward current requirements, so have fun building a good and cheap driver for 100W RGBW.
LEDs can easily be wired in parallel as long as you use resistors to balance them. If you dial in the voltage real tight you can get away with minimal losses in the resistors. If you are really fancy you can use transistors and shunts to actively balance then for even more efficiency.
The reason why series is more popular is actually because it is cheaper and(can be) more efficient. It's not uncommon for cheap led lights to just throw 40 leds in series with a dead simple "driver" (read: rectifier, smoothing caps, and a resistor)to run it right off 120V.
Similar issues can affect parallel. If one LED fails open and you don’t adjust the current, you’ll start overdriving the other LEDs and shorten their lives...potentially dramatically. You could add current sense and shut down the board or even adjust current, but then costs go up.
Typical LED strips are small serial strings of typically three lights connected in parallel. That way if something goes wrong you knly lose a few lights.