As far as either of us know, it's common knowledge among anyone other than the 'katanas can cut steel beams' crowd that Japan was very very iron-poor, was alloying-elements-poor, that their folding technique was not unique by any means, and that noone including Japan sharpened swords to a single molecule's thickness on the cutting edge for good reasons relating to durability. (You could, if you wanted to, fairly trivially sharpen your kitchen knives at least near that degree. You wouldn't want to, for the same durability reason.)
My wife is now professionally a neuroscientist, and they do use scalpels that precisely sharp, or even sharpened tungsten wire 'grown' chemically into that configuration for precision work like cutting into a single cell of your choice under high power microscopy. But all of those are nearly single-use-only instruments. To the extent they can be reused, it's because they only touched very soft cellular material and never contacted something anywhere as hard as a cutting board, much less a bone -- as both kitchen knives and combat swords would do routinely in use. You really don't want the tip of your blade folding over upon itself, which happens almost immediately with a blade that thin. If curious on this topic, investigate the advantages of a beveled (multi-angle) grind, common on a chef's knife, vs a hollow ground edge like you might find on a santoku kitchen knife -- particularly pay attention to the difference in maintenance required of each.
I expect googling for 'japan iron-poor' and 'sword folding technique' would immediately shed light on either of those areas, if you're still in search of a citation.
I haven't heard of anybody who knows much about the subject intentionally limiting how small they make the edge radius of a knife to preserve the durability of the edge. It's nearly always desirable to get the edge radius of a knife blade as small as possible, because it will take more wear or deformation before it's too thick to cut effectively. There is some subtlety though: a wider bevel angle is more stable and obviously adds resistance when cutting, though it can actually result in a smaller edge radius. A convex grind improves both stability and edge radius, but is more difficult to produce. My gyuto has a convex primary grind, but the edge bevel was straight, as a flat stone would produce.
A santoku doesn't typically have a hollow grind, though some specialty knives like the yanagiba are typically concave on one side and flat or convex or the other.
There are some interesting electron micrographs of hand-sharpened knife and razor blades at https://scienceofsharp.wordpress.com/