This looks like a different structural fin design, so maybe they’ve fixed the noise issue, but you still have an open sidewall to fill with mud, ice, rocks, etc...
This looks like a different structural fin design, so maybe they’ve fixed the noise issue, but you still have an open sidewall to fill with mud, ice, rocks, etc...
> "If you have a load on the tire and you cut all the spokes at the bottom, you will see that nothing will change, demonstrating that the load is carried by the top of it, not by the under parts." Other airless tires, he said, often carry the load at the bottom of the tire, which is very inefficient and causes extra heating due to compression.
Tires like these already exist for industrial equipment, Michelin does need to address these very real concerns. I am also concerned about the ecological impacts, it appears the tire uses more rubber than conventional tires, the only way this isn't worse is if it is safely recappable. It may be, but again the article doesn't state so.
"Although it is acknowledged that the initial prototype automotive Tweel tires did demonstrate flaws with regard to noise and high speed vibration[5] and produced 5 percent more friction compared to a radial tire,[3] these early issues were resolved in subsequent prototypes, and current automotive Tweel prototype products have been shown to be well behaved and reliable."
My guess is it'd keep the air in which you don't want with an airless tire.
Just add a valve that allows air out if the interior pressure rises more than x% above ambient atmospheric pressure, and allows air in through a filter if it's more than y% below. It wouldn't be that much more complex than the stem valves already added to tires.
The primary goal is to keep contaminants out of the interior tire structure, but a secondary marketing goal should probably be to make them look like normal tires at first glance. Wrapping the internal structure in something that looks like "normal tire" serves both.