Whereas a catastrophic dépressurisation event on a hyperloop will assuredly kill everyone inside. The amount of energy stored in such a pressure differential is equivalent to many hundreds of tons of TNT. It's not comparable at all.
[1]https://en.m.wikipedia.org/wiki/2017_Washington_train_derail... [2]https://en.m.wikipedia.org/wiki/List_of_rail_accidents_(2010...
If the hole stays of fixed diameter, its throughput would be small compared to the volume of the tube, so pressure would increase gradually.
So, how feasible is it that hole would not increase? What hyperloop designs are there? 10 inch thick steel throughout whole length?
A 50 cal APDS bullet would punch clean through the first layer and would likely leave an inch thick hole, and would likely cause significant damage on the other side if not penetrate it outright. This is almost certainly sufficient to cause explosive pressurization, which would likely cause immediately more damage and eventually create a powerful shockwave that would destroy anything in the tube.
Of course, a bomb next to the wall would be much worse.
If it was a 10 inch thick steel tube, it would be much better, but also ten times more expensive, making it prohibitively expensive.
Yesterday an Air Force helicopter was shot at and the pilot injured. Not to mention the number of citizens pointing lasers at cockpits.
https://www.wusa9.com/article/news/local/virginia/military-h...
You can't refuse to do something just because you're scared of a few bad actors. Otherwise we have to stop making cars (they get driven into crowds), building tall buildings (they get bombed or have aircraft flown into them), drinking public water (they get threatened with poisoning attempts), blah blah blah.
Making an entire transportation system with hundreds of thousands of people inside that can all be killed instantly by a single bullet or bomb is insane lunacy.