You can actually repeat the coiling process on a bandsaw blade one of two ways (theoretically, there are probably more, practically, if you have blade long enough to need to, please invite me over so I can ogle your saw):
1. Repeat it with the whole 3 coil loop, which gives you a 9 coil loop. Uncoiling without injuring oneself is a bit tricky, as bandsaw blades are quite springy, and it's hard to uncoil the blade in two discrete steps one it's in a nine coil loop.
2. Gather the three coil section to one side (or equivalently, extend one of the three coils) giving the gathered section about 1/3 the total size of the exteneded section, then repeat the process with the exteneded loop in one hand and the gathered coils in the other yielding a five coil loop. It's still tricky to get the whole thing uncoiled in 2 discrete steps, but you've stored a bit less energy in the coils of the blade and it's somewhat less hazardous.
I wouldn't suggest trying either of these with a 93 1/2" blade (the standard size for 14" saws), but method 2 works well with a 162" blade.
I took a knot theory class in college and there are actually two characteristics, twist and writhe, that are quantifiable and can be exchanged by coiling and uncoiling (massive handwaving, bad terminology, etc. That class was a long while ago). If you've ever taken a garden hose in a flat coil (with all the coils in the same direction) and pulled it out without unwinding it, you've enjoyed an illustration of this.