Likely the "pins rubbing" you mention doesn't really matter, because the wear from inserting and removing the chain as it cycles around has to be a miniscule fraction of the wear that occurs under load.
Likely the "pins rubbing" you mention doesn't really matter, because the wear from inserting and removing the chain as it cycles around has to be a miniscule fraction of the wear that occurs under load.
In a worn chain, the rollers engage high up, and then work their way down (under high load) until seated at the base. In the unworn condition, engagement begins at the base of the tooth where the forces are better spread over the roller.
In point of fact, the forces are spread out over more teeth when worn. The first tooth engagement might begin 3mm high, then 2.5mm, then 2mm, etc. over ~6 teeth. Whereas the fresh chain might manage 2 or 3. But the wear and friction of the worn chain is much higher as you have a great deal of motion under high load as the loaded rollers creep down. The unworn chain has perhaps higher loads, but the roller is essentially seated and immobile at the base of the gear for this.
Not at all! The article claims 98% efficiency.
Roller chains are used to transfer torque in bicycles and motor cycles, inside internal combustion engines to drive cam shafts... and many more applications covering a huge range of power levels and environments.
Not only is it efficient, it's cheap.
If that last 2% of efficiency was important (or easy to obtain) it would have been on a GP motorcycle already.