... isn't it ? my internet box is from something like 2014 and is able to choose the less used wifi band automatically.
... isn't it ? my internet box is from something like 2014 and is able to choose the less used wifi band automatically.
Transmitting at the max allowable power is the selfish and dumb solution. It isn't the best solution, in a world with multiple overlapping WiFi networks. It isn't even a Nash equilibrium.
Yes, your received signal to noise ratio for that transmission will be somewhat decreased, and that might (or might not) hurt data throughput meaningfully. But it also means that your transmissions are causing less interference for your neighbor(s), and as a result your neighbor's equipment will not have to send as many retransmissions that potentially interfere with your own communications. It's a second-order effect, but also one that's proportional to how many neighbors you have in range that are trying to use the same slice of spectrum. So it's entirely possible that by unilaterally shouting less, you cause a significant reduction in wasted airtime that benefits both sides (though probably benefiting your neighbors more than you, depending on where your priorities lie between throughput and latency). It's not always a zero-sum game.
In general (at least for WiFi), it's better to worry about airtime as the scarce resource rather than focusing on bytes per second. For fixed-rate wired networking, transmit time and bytes delivered are exactly proportional, but a variable-rate shared wireless medium decouples the two.
I don't think you quite understood what I was saying: that decreasing your transmit power can actually lead to better overall network performance for you (and your neighbors) without requiring any corresponding change in strategy from your neighbors. Therefore it is not always an equilibrium (this may depend on the severity of local congestion).
Also, TX power is not all about interference: attenuation, there is very good reason to transmit at max power for best wall penetration / range. Even in a suburban/rural setting, with more and more devices connected remotely, you need the range. It's not in a manufacturer best interest to decrease the range of their routers. Only a small fraction of user will look at setting the TX power / investing in a better antenna / setup mesh network. The first reflex will always be "buy a new router".
So once again, max legal transmit power is the best overall bet.
Could you please try to re-write that sentence in a way that gives me some indication that you actually read and understood my last two comments? Because it seems like you're simply repeating an assertion without addressing any of the points I brought up, and I'm not sure whether my explanations were inadequate or just unwanted.