Sure, it would be great to have connectors for everything and support for every cool standard but these guys have to give up all what is non-essential to keep it small, cheap and possible to engineer by a small team.
Sure, it would be great to have connectors for everything and support for every cool standard but these guys have to give up all what is non-essential to keep it small, cheap and possible to engineer by a small team.
There's no reason you couldn't kick SD transfer speeds up towards SSD speeds other than the protocol doesn't allow for it.
SD is fantastically simple, so that the boot rom can get at a bootloader without much effort (generally the bootrom just looks at a memory offset on the mmc device). Once you start speaking newer faster protocols, this simplicity is lost. You're not likely going to find a bootrom that implements all the bits needed to get u-boot from a sata device.
In a perfect world, once these are no longer developer devices, the mmc would be replaced with some spi flash (or even an emmc) with just u-boot.
On 90% of embedded dev systems, you're better off thinking of the sd card as a "bios chip" then a hard drive. The fact you can also use it as a block device to store a rw filesystem is almost incidental, and should probably be avoided.
Oh, that's a nice idea! It would be nice if you linked to a guide or wiki page so that more people can replicate your setup.
Also, CFast aren’t as ubiquitous as microSD. I can go to Target or Walmart and get a wide “selection” of microSD, but I’d be hard pressed to find a CFast card. So the chances of an SBC using CFast over eMMC or microSD is low.
There is one. It's called UFS 3.0. The Sony Xperia 1 II has it. They're same size as MicroSD, but look slightly different.
https://store.shopping.yahoo.co.jp/rarahu-store/B085B2LTLB.h...