Only high-bandwidth signal groups (such as HDMI) have the limitation of being usable at only one (or a few) positions. Technically these too can be given more/complete placement freedom, but at the cost of a higher PCB layer count, or exceptional noise-immune routing skill, which I presently don't have. I plan to hire a layout expert to assist with the DFM eventually.
The current PCB routing is done such that about 90% of blocks can be interfaced at almost/all positions. (I'll make a more formal statement later after verifying this number.)
This was in fact a foundational aspect of the design -- "How can the classic breadboard be made (a lot) more powerful at the cost of as little flexibility as possible?"