Can Electronics made of COTS components work at cryogenic temperatures? (2020)
onelectrontech.com
onelectrontech.com
Thus, a big part of the Mars probes', including the Ingenuity micro-helicopter's, power budgets is keeping them warm enough overnight. The Voyager spaceprobes will be shut down soon not because they can't produce enough signal to reach Earth antenna arrays, but because they can't keep the equipment warm enough to work right.
It would probably be possible to make stuff that would work cold, but there aren't enough places to use it to support the whole process.
I could understand that you want to avoid temperature changes as much as possible to avoid stress on the components. But why settle on an arbitrary temperature that is comfortable for humans? Of course I learnt quickly that a room temperature design makes a lot of things much easier;-)
[1] An interesting tidbit is that in certain fields room temperature is used as a technical term to really mean a well defined temperature, and that there is a difference between North American (25 °C) and the European (20 °C) convention.
1. Assuming it's easy to keep 20C (I thought it's problematic to keep such a low temp for satellite which has problem radiating heat away), what about transfer, is electronics not yet operating back then or do you use some heating elements specifically for bootstrap?
2. Just to be clear 25C is what is used as room temp in electronics and not something you set your thermostat too at home, right?
3. (easily googlable feel free to skip) - how does heat management look for satelatie electronics? Are peltiers used? Do you just put everything in some heat conductive material? Is there some gas sealed around PCB or is it vacuum? In case of the latter and if everything is not surrounded by some heat conductive substance how do you deal with thermal runaway? Is maybe PCB itself and paths enough to make it less bad than I imagine?
Thanks a lot, I'm sorry about so many questions, just got curious.
(note: Florida Man Sets Thermostat)
The biggest issue is getting heat out, though my module was on a cold plate and I doubt it was ever cycled to those ranges.
The concern was keeping output power and current within spec over those ranges; getting enough output power (within distortion specs) at hot, and keeping the current under spec at cold (so as not to trip a breaker).
I worked for a telecom that deployed a lot of equipment at high latitude, in places where temperatures could reach -40 or colder. It wasn't my department, but I had the impression that we weren't really paying too much attention to the lower end of the operating range specified by manufacturers. I recall seeing "ice in the feed horn" as a root cause more than once.
Of course, many COTS components specify much higher minimum operating temperatures in their datasheets, so thoroughly characterizing these components is vital for high-reliability operation in cryogenic conditions.
The server is temporarily unable to service your request due to maintenance downtime or capacity problems. Please try again later.
Additionally, a 503 Service Unavailable error was encountered while trying to use an ErrorDocument to handle the request.