Semi-Solid Casting Enables Net Shape Volume Manufacturing
engineering.com
engineering.com
This augurs well for SSM casting, since precise control is immensely cheaper in 02021 than it was in 01977.
Interesting things to know, but not something directly applicable to me. Thanks for posting it.
For laptop sized parts, semi-solid rheocasting,thixomolding is much cheaper than conventional casting on per part basis, and usually gives you superior fine features like studs, ribs, thin walls, and thus greatly reducing the need for final machining.
Downside is that semi-solid casting/molding machines are much more expensive than conventional ones because of powerful hydraulics, up to few times as much ($300k-$600k for making CE parts,) and the cost grows much faster than the maximum part volume. The alloy for them is also much more expensive than common aluminiums.
But on scales of consumer electronics manufacturing, material costs are minuscule in comparison to everything else, and the net shape capability is 100% worth the premium.
Both techniques will give you equally high material strength, but you will be paying much more for quality for conventional casting, to the point the cost advantage is lost.
Stronger low silicon alloys will need higher casting temperatures, and pressures to compensate for lower castability, and will also need degassing equipment, more expensive molds, and more extra equipment in general.
On the size of car chassis, I may bet the material cost will start to make a difference.
As a rule, you will need a lot more extra material to compensate for overall lower strength of cast parts.
So it is basically a CapeEx issue? Are there any other drawbacks?
It seems to be on paper, if you are working on a small item, with a target market of non-bottom quality product where you have a chance to charge a premium, this seems to be a no-brainer.