Application of automotive alternators in small wind turbines (2012)
repository.tudelft.nl
repository.tudelft.nl
Besides being able to scavenge alternators from junked cars, potentially lowering the cost-per-watt, there must be economies of scale that are pushing toward absolute garagutan wind power converters (there is nothing 'generated' here, that's a bad term. Power is converted.) https://www.nytimes.com/2021/01/01/business/GE-wind-turbine.... GE Haliade-X 13MW Wind Turbine, 722 ft diameter, 853 ft high. (The 86th floor observatory on the Empire State Building is at 1,050 ft)
Well yeah. Twice the diameter is 4x the available power at the same wind speed. Wind tends to be faster higher up too.
https://newatlas.com/energy/worlds-biggest-wind-turbine-ming...
There's a lot of idle surplus units everywhere, plus almost all of them in use only generate electricity when fuel is being burnt. So there's plenty of upside by repurposement for widespread capture of new clean energy.
However it seems like the use of a field coil instead of permanent magnets is a compromise in efficiency that was made to save cost per unit, especially considering that the potential energy generated in excess of nominal is always going to be unused in automotive application.
I would like to see them take a look at the much more uncommon commodity units having permanent magnets and go through the equations on that. Like from farm equipment or even actual portable or stationary generators where the IC engines are worn out or too costly to run but the electrical parts can be repurposed.
Could probably come up with some fairly simplified rules of thumb about mechanical interfacing for wind capture, plus electrical interface for delivery, and I would expect both to be quite a bit different than the field coil units.
Moving up to a ratio of 10 would be best using more advanced circuitry.
So put a huge gear on the shaft of the water wheel and a tiny gear on the shaft of the alternator.
What tons of people do to play around with the optimal setup is to use an old bicycle rear tire for the water wheel and the whole chain and gears setup to connect to the alternator. That way you can change gears while it's running and figure out the optimal gear ratio.
https://www.thebackshed.com/windmill/Contents.asp#3 has some details, and in the forums there.