https://www.aerodefensetech.com/component/content/article/ad...
More thrust even at lower specific impulse at the start of the flight can save you a significant amount of gravity loss, engine mass etc.
It also depends on the engine configuration, you could do much better in terms of weight and density.
Engines used on a first stage typically have high thrust, but that's because they're designed with large throats, not because of the propellant they use.
A dense propellant does allow the pumps to be smaller. But I don't think that's going to help much in a NTR, since the reactor itself is heavy. The problem with an NTR is the difficulty of getting high mass flow past very thin fuel elements (the thinness necessary for high heat transfer) without destruction of the fuel elements by that flow. The thin fuel elements also ensure some fission products will escape and be carried off in the propellant.
and that gets close to my favorite - air-augmenting regular rocket engine. Very simple and bumps up your thrust and ISP up to 2-3x http://www.astronautix.com/g/gnom.html
> The engine is extremely low cost to produce, as it is completely additively manufactured (metallic 3D printing) in only two pieces.
Anyway, there's a bunch of stuff they're not including in this statement; it's like "we can print your car's engine block" but glosses over the additional whirly-sparky stuff that turns a lump of metal -- even if it is in the right shape -- into a functional engine.
The F9 and Electron both aggressively drove down costs using 3D printing
Also 3D printing has the advantage of not throwing out 75%+ of the metal stock
COST_3D-(COST_CONVENTIONAL+SALARY_MACHINIST) = SAVINGS
is more than the literally unreproducible parts 3D printing can achieve. These are not comparable quantities.
The way I see it, there are roughly infinite previously non-constructible parts that by definition we as a society couldn't test. Now that we can construct these new parts, shouldn't we test them and then use them if they are better/cheaper?
High performance heat exchangers for applications where every gram counts for example were hand made like a jewelry work at a huge expense.
I spent 10 years working in electronics, and not only manufacturing.