A torque wrench is better than a Smartbolt once it's put on the fastener, but the Smartbolt can be measured just by looking at it.
An HN company does a similar thing with RFID tags for grease zerks:
Again, it's not so much about measuring that the precisely right amount of grease was dispensed, but that every one of the 37 grease points was at least near the tip of the gun once every 30 days for the life of the equipment; the operator didn't forget about that one zerk that's hard to see and grease only 36 zerks for 5 years...
Ever wonder why the tire shop has tightened your wheel lug nuts so tight that you can't get them off with the hand wrench when you need to change a tire? They spin them on with a pneumatic impact wrench, and then "check" the torque with a torque wrench. Of course it clicks, because the nuts are already way too tight.
(I could of course have bought new bolts, but I always forgot about it after spending 2 hours changing the tires …)
If you think dealership/tire shop/corner shop garage techs touch a torque wrench for lug nuts, you're dreaming. They blast each nut on with the gun and walk away.
Techs never are incentivized to get everything done as fast as possible because they're paid by book rate, and there's zero disincentive for not doing it properly.
Torque sticks were an attempt to address the problem but most techs can't even be bothered with those.
Proper torque for lug nuts is multi-step anyway. Star pattern partial tightening, with the wheel placed correctly on the hub if it doesn't have a concentric ring - then full tightening, then re-checking after the vehicle has been driven for a few minutes, because of fretting between the wheel, rotor, and hub surfaces...even if you've carefully prepped the surfaces, which again, no automotive tech does.
Emphasis on properly torqued: in the field threads or bolt heads might be dirty, or torque wrenches might be out of calibration, adding even more uncertainty.