Especially on a prototype I'd recommend them. Prototypes are really expensive, a complete supply of Nord locks for your project is probably less than a single one-off CNC part.
Note that Nord locks are specced to be single use. Not that I've never reused some on prototypes, but, well, I'd never do it on a life-critical joint that is meant to be taken apart often.
> Especially on a prototype I'd recommend them.
> I'd never do it on a life-critical joint that is meant to be taken apart often.
Very good/helpful feedback. This thread is giving me much more confidence to make the extra upfront investment. Thanks!
When I’ve used them, it’s been for critical fasteners where ease of assembly was important, and could not be effectively decoupled from vibration, and where our recommended inspection/maintenance cycle was not guaranteed.
You might also consider something like a pinned castle nut, or safety wire, etc. These are not as simple to specify or install but more cost effective. Also, I’ve seen safety wire used as a conductive link to detect failure in a remote application.
Which is odd, given their simplicity and ease of manufacture, etc.
Can you get them stainless or just HDG ?
> When I’ve used them, it’s been for critical fasteners where ease of assembly was important, and could not be effectively decoupled from vibration, and where our recommended inspection/maintenance cycle was not guaranteed.
Taken to heart - sincerely appreciate the insight!