The summary is that a cheap electric kettle can boil water way faster and with far less wasted energy than a stove top kettle.
The summary is that a cheap electric kettle can boil water way faster and with far less wasted energy than a stove top kettle.
It’s unfortunate that in the US our electric kettles are much slower than in the U.K.
The big question in my mind is whether the electric kettle itself is the "final form", or if I'll be proselytizing the same people in ten years to get an Asian style hot water heater/reservoir instead.
- work when power is unavailable (outages, camping, etc.)
- are more or less indestructible
- don't take up counter space
I have one of those big 4L Zojirushi electric kettles that I keep plugged in for 8-10 hours a day. Sometimes I will use the stove top kettle for supplementary boiling water when people in my household are using the electric, or I don't want to start a reboil cycle or take too much at once.
Small nit-pick: Electricity generation itself is often very lossy. In the case of fossil sources, the energy waste is just further up the chain (with solar power too, but it matters much less).
A good combined cycle has power plant is about 60%, transmission is about 90%, and an induction stove is about 85%. That gives a net efficiency of 46%.
A gas stove is one of the last things that should be converted, because heat is the most efficient use of fossil fuels.
In general, any conversion of heat energy to mechanical or electrical energy will have a fairly low efficiency, so switching an energy source in a way that adds such a conversion will have at best a small benefit.
On the other hand, switching from a gas to an electric car requires an extra heat->mechanical conversion step at the power plant, but it removes a heat->mechanical conversion step in the car, so in general this is a favorable trade.
You can also get a favorable trade in home heating if you replace a gas furnace with an electric heat pump, or a gas water heater with a heat pump water heater, because the heat pump can get effectively well over 100% efficiency.
Just because both are "lossy" that does not mean at all the losses are of comparable magnitude.
So, actual question: "You need X amount of gas in a power plant to generate enough energy for 1000 households to heat their water with induction" vs "You need Y amount for the same number of households using gas stoves". What is the ratio between X and Y? You claim it is about 1. Is it? Or much larger than 1 or much smaller than 1?
https://www.nytimes.com/2019/05/29/climate/nyt-climate-newsl...
"an overall efficiency [of a gas stove was] only 30.5 percent"
"The microwave was a bit better; it clocked in at about 43 percent efficiency."
"[Electric kettles] hit 70 percent efficiency."
And it can cost a pretty penny to get a building up to this standard.
[1] Though it must also be pointed out that older housing stock tends very strongly to be electric anyway. Gas cooktops have always been high end devices. People renting buildings in old urban neighborhoods never installed them.