One neat trick (I remember reading about from Alan Cox I believe) if you have control over the hardware is to memory map I/O devices like serial input / output such that incrementing addresses starting at a given address all point to the same physical device/register. E.g. allocate 256 contiguous bytes in your memory map to point to the same thing. This way you can do bulk I/O transfers to/from memory using MVP/MVN instead of "get a byte, put a byte" instruction by instruction.
If you're moving memory around in bank 0 (or have memory mapping), you can use the direct page register to read/write anywhere in bank 0 and the stack to read/write anywhere in bank 0.
16-bit LDA dp, PHA is 4 + 4 = 8 cycles or 4 cycles per byte. Best case would be if you know it's constant data before hand, eg, LDA #0, PHA, PHA .... 2 cycles per byte!
For general purpose copying MVP and MVN are easier and have better code density.
"The emulator also has a fun hack for disk performance I'm hoping will get replicated in some of the upcoming retro 65C816 board design. Like the 6502 the 65C816 sucks at continually reading from an MMIO port and writing it to sequential memory locations. It sucks less than a 6502 because you've got 16bit index registers, but at the same clock it was doing about 100K/second that a Z80 can do 250K (with ini loops). The revised emulated disk interface has the same mmio port replicated across a chunk of address space and this allows a block move instruction (MVN) to do all the work at 6 clocks/byte. At that point the 65C816 suddenly jumps to twice as fast as the Z80 on disk I/O."
https://forum.vcfed.org/index.php?threads/performance-of-lo-...
Port IO Read Speed : 219.39 KB/s
MMIO Read Speed : 310.77 KB/s
Some variants of XTIDE hardware also implement this, as does the free bios.