FFT essentially just transforms data into its frequency domain, so I assume the representation shown in the article is just that, brighter spots indicate higher frequency information (which would come from all the little spaced dots), so killing those essentially smooths the noise out of the data.
I imagine that the same effect could be automatically achieved by identifying which frequencies to filter out to get the desired effect.
you can think of it as a polar plot where: radius = frequency, angle = angle (as in points along the horizontal direction in the FFT correspond to e.g. vertical stripes in the image), brightness = power
There is an imaginary part to the FFT that contains the phase-shifts needed to add everything back up into the original image. You may have noticed that the "FFT of the image" is symmetric, so something else should be needed to compute the inverse.
If we were sure that the halftone resolution was smaller than the relevant details of the photo, then we could just use a low-pass filter (a circular aperture), removing all the high-frequency components from the halftone print, but keeping the details of the photo. However in this case, the photo has details that are at the same scale as the halftone.
So the next best thing is to try to infer the halftone noise spectrum and subtract it, which is hard because it's mixed in with the photo, and we don't know which spectral peaks are from the photo and which are from the halftone process. What we can guess is that the legitimate high-frequency information in the photo should be pretty random, meaning it will be smeared out across the fourier spectrum, while the halftone print will be strongly periodic - concentrated into dots that are nearly symmetrically distributed around the origin (with some radial pattern that depends on the print process), away from the low-frequency center point.
Based on this we guess that any big dots that are symmetrically placed around the origin are probably more halftone noise than image signal, and any grey areas between them are probably more real image data than noise. Then we fit a noise filter to the dots with a regression, doing our best guess to invert the noise, bringing the whole high-frequency zone to approximately a uniform grey.
And then we hope that the picture isn't a photo of a herd of small spotted leopards.