I hope this helps. Just be aware that sometimes components are coupled or you may need to do some minor soldering (which in this case, is probably necessary). The good news though is that if you intend to NEVER use the microphones again, then this is much easier because if you do a little damage then it doesn't matter. To remove those surface mounted mics shouldn't be that hard, but again, patience is key. Use the largest (preferably flat tip, like a flathead screwdriver) soldering iron tip you can get in there and just push (since we're not worried about repair, you don't have to be as concerned about heat).
[0] https://www.ifixit.com/Guide
[1] https://www.ifixit.com/Guide/Google+Pixel+7+Pro+Earpiece+Spe...
[2] https://support.google.com/pixelphone/answer/7157629?hl=en#z...
[3] https://arstechnica.com/gadgets/2022/10/pixel-7-pro-teardown...
I am a noob at soldering but I have done a tiny bit before. Maybe I can get this done after all!
[0a] Great demo, showing simplicity: https://www.youtube.com/watch?v=5uiroWBkdFY
[0b] A bit more detailed and Dave is just always extremely entertaining and a wealth of knowledge (notice his "go to" tip. Professionals use chisels ;) : https://www.youtube.com/watch?v=hoLf8gvvXXU
[1] https://www.amazon.com/UY-CHAN-Original-Soldering-Replacemen...
It's also possible to read lips and monitor typing or writing motions using 802.11, so that's another modality. In addition, your phone's baseband could potentially be used for those same purposes given it affords access to an additional spectrum of RF.
But as far as interesting and what is possible, these comments are that.
They weren't intended to. That said, I otherwise agree with everything you said.
>But as far as interesting and what is possible, these comments are that.
Yeah, it's just fun to discuss the theoretical. I'm pretty boring, so I don't personally use any exotic tinfoil precautions. Heck, if I were important I'd probably just not use a phone. Much simpler.
Doesn't that require the router to cooperate? As in, this is something that was developed to be used on purpose, but it's not very reliable on a random network you don't own.
You can see a lot of timing info from network sniffing even if you can't read it of course.
That was my primary assumption. Worst case, modern phones can act as hotspots—so if your phone is owned but stuffed in a drawer, it could theoretically sense beyond that and perhaps read your lips from another room. I'm guessing any stereotypical white vans worth their salt would provide fake devices for your phone to connect to in that case.
On the baseband side, perhaps Stingray setups have the potential to be more useful than commonly imagined.