It's very easy to squeeze a bit too hard or not quite get the grip right and the part will ping off and you'll never find it.
If the tweezers get a bit of solder paste on them the components start to stick so you can't let go of them.
It's really hard to get the components out of the tape - so you tend to have to tip them out and then they are upside down so you need to flip them over. Which is really hard with tiny components and again you often lose them.
For larger components (e.g. MCUs) its quite hard to pick them up in a way that is easy to place with tweezers.
In a production setup, the pick and place machine accepts the reels and uses a vacuum tool to pick the parts up. It knows the orientation of the part in the tape (which is fixed) and where it needs to go on the board. Often components with irregular tops (usb connectors for example) will have small piece of kapton tape fixed to them to aid pickup. This is important: if you're doing this with tweezers, it's often annoying to pick the parts out of the tape and if you dump on the table you usually have to flip things the right way up, rotate them, etc. So a vacuum tool makes that a lot easier.
Small pens already exist and so do diy options like aquarium pumps, but this is a really polished looking project and great if it's open source too.
Can't do it with just forceps, which are fine for smaller parts.
It's just more convenient using this.
For example TQFP-144 and fBGA256 parts are hard to place with forceps alone. Let alone larger parts.