Having your home heat up to 90 degrees while you're doing some weekend errands only to crank the AC to cool it back down to 70 to 75 will often times use more electricity than if you just set the AC to 80 while you were gone.
Having your home heat up to 90 degrees while you're doing some weekend errands only to crank the AC to cool it back down to 70 to 75 will often times use more electricity than if you just set the AC to 80 while you were gone.
I've seen similar statements a few times, even in this HN thread. Most articles just repeat the statement without showing any numbers. This article does show numbers and the graphs. From the article:
> What we found was that even when the A/C temporarily spikes to recover from the higher indoor temperatures, the overall energy consumption in the setback cases is still less than when maintaining a constant temperature throughout the day.
Full data on https://theconversation.com/does-turning-the-air-conditionin...
I don't think it's always true, which is why I listed the factors that can influence it.
But I am also getting into home automation and just watched a video where some one ran through the numbers on their specific house after getting electricity monitoring connected to their heating and Home Assistant. It's not that clear cut and really depends on your specific home.
1. You run the A/C all day: the gas stays both cold, and dry. Cold, dry air is, it turns out, ok as an insulator. Not very good thermal conductivity at all.
2. You turn the A/C on at the end of the day in a warm, humid environment. The air is moist, which causes two compounding problems: first, the volume of air you need to cool just holds more energy than it would if it was dry. But second, because moist air is more thermally conductive, it's better at coupling heat in from the outside, so more energy is coming into the system as you're trying to cool it.
At least, that's the argument. I haven't run the numbers to check orders of magnitude or anything. I wasn't expecting the difference in thermal properties of dry and moist air to be that significant, but there are some very interesting numbers at https://www.engineeringtoolbox.com/moist-air-properties-d_12....
One main reason is that when AC is off is that humidity increases which causes cooling harder. This is because the cooling process of an AC unit involves removing humidity from the air as well as heat. When the air is humid, the AC unit has to work harder to remove the excess moisture from the air, which can decrease its overall cooling efficiency.
The other reason is that house and furniture will store heat and then cooling will get harder.
Also AC runs more efficiently if its constant.
I only know of two mechanisms that could make holding a temperature more efficient. Heat pumps in winter time should be left to maintain a temperature. If it is well below freezing outside the heat pump may need to fallback to a secondary mechanism of resistive heating. Therefore it's better to not setback the temperature immediately when the home is unoccupied. Variable speed fans on higher end furnaces use less energy at lower RPM, so running a system at full effect requires more power.
Your refrigerator will also work harder as the ambient temperature climbs.
I think that's just power companies not wanting everyone to turn on AC at roughly same time is the reason for those power "saving" tips.