Maeve unveils plans for 80-seat hybrid regional airliner
aviationweek.com
aviationweek.com
Incidentally this identical concept is already being pursued by Pratt & Whitney Canada using an existing (and very successful) airframe, the DeHavilland Dash-8. An aircraft even mentioned in the article as an aircraft Maeve wishes to replace. Proven aircraft, with a proven engine manufacturer. I'd be betting on the P&WC and the DeHavilland team on this one.
https://www.prattwhitney.com/en/newsroom/news/2021/07/15/pwc...
That's the first time I see hints of regenerative braking for electrified planes. But the article mentions it only in passing, so it may not amount to much.
Charging during descent is much more likely to be some sort of air brake generator. You can imagine, though, that a well-done “electric take off assist” would be seen as a safety improvement.
Regulations considering all such things, because of this, decision to make landing, taken by captain, considering weather conditions, technical state of aircraft, and physical state of crew.
So, in ideal conditions, many such planes could make landing on just some 200m, but in reality, they flight only on strips approx 1500m or longer, for safety considerations.
A hybrid aircraft is going to have smaller engines that produce less thrust, and probably take longer to get to max thrust. Because the electric motors make up the difference during takeoff.
Consider what happens when lightning strikes an airport. An immediate ground stop is issued and every airplane in the air that can GTFO has to GTFO.
And remember the near accident earlier this year when the FedEx plane almost landed on the Southwest plane.
A regenerative braking system reduces the maximum thrust available if an emergency happens near the ground when you are landing and you really really want to stay in the air. I don’t think we are willing to make that trade off for lower carbon emissions.
Which is why I think they would find a way to make sure the batteries are charged before that final descent.
Now that I think of it, perhaps I should be clear that when I see “regenerative braking”, I am thinking about something on the brakes on the wheels on the landing gear, which perhaps is not how everyone else thinks of it.
True.
> and probably take longer to get to max thrust
False. But it is not important.
For passenger planes, usual, to have rich wing mechanization especially mentioned model is one of most sophisticated on this.
But mechanization have huge drawback - it usually increase Cx very significant when activated, so engines must run with moderate power (without mechanization, descending made with throttled engines to near zero).
After touchdown, plane is technically on ground, but in reality it usually have very high speed, or huge kinetic energy.
When engines ok, on nearly all civilian planes, they turned to reverse and braking (military planes usually don't have reverse).
And only after speed slowed to ~150km/h (approx 100mph), activated wheel brakes.
And this is not because I want to do so, but because kinetic energy is too high for wheel brakes, and because it is just extremely dangerous to brake the wheels on so high speed.
Some decades ago, plane constructors even included special ballast to breaks to accumulate heat from plane braking, and for example, Concord does not have reverse, totally depend on wheel brake, for it created ABS system, and it's breaks cooled approx 11 hours.
You don't hear me. Regulations consider worst case, so for this plane, will be required longer strips than for original (non-hybrid). Nothing less, but nothing more.