Plastic piping in general is already disallowed in a lot of commercial construction.
ABS is a valid alternative in some parts of the country, but is often already banned from being used in even residential construction in places where it gets very cold in the winter, as it shatters easily.
This is an understatement. This would essentially kill off plumbing as a DIY task and be a huge boon for professional plumbers.
And some well water and reverse-osmosis-filtered water is not so friendly to copper.
"Yep, that 5" hole in the side of the pipe sure keeps everything flowing."
Heh.
The manufacturer could put a warning label on it, but you and I both know how well that's going to work in practice.
Edit: oh, and the reaction produces large quantities of hydrogen gas, for extra fun.
I'm not super-fond of the so-called "no-hub" joints for cast iron. IMO, the rubber is just waiting to deteriorate underground and cause an expensive nightmare 20 years down the road.
You can of course run extra heavy no-hub couplers (four or more worm clamps per joint).
DIY: do-it-yourself (fairly widely known)
PEX: Cross-linked polyethylene, a form of polyethylene with cross-links. Increasingly prevalent in plumbing applications.
PCV: Polyvinyl chloride, a common plastic pipe, often white or black, may be rigid or flexible, widely used in plumbing for decades. "the world's third-most widely produced synthetic polymer of plastic (after polyethylene and polypropylene)" per Wikipedia.
EMT: Electrical metallic tubing.
I would much rather use ABS in applications where it works.
You usually don't need expansion joints on cast iron...not that most residential construction gets them even when they are needed.
It's detectable in an X-ray, unlike PVC, though I doubt that's of interest to 99% of DWV applications!
No-hub is easier to adjust and rework than glued plastic pipe, as you can always loosen the coupling. Hub-and-spigot with rubber gaskets is effectively permanent, you have to seat it with lube and a mechanical assist puller usually. On the old lead and oakum joints, you can always dig out the lead to change orientation (not fun), or caulk it (as in with irons) more if there's seepage on a line.
It also does not produce toxic smoke if there's a fire.