Much greater conductivity than what? I assume there are other non-REBCO layers in the tape, but the article neglects to mention them.
Much greater conductivity than what? I assume there are other non-REBCO layers in the tape, but the article neglects to mention them.
If you have two resistors in parallel, the current in each is proportional to the ratio of the resistances. But what if one of the resistances is zero? Then all the current goes through that resistor. So if you have a superconductor in parallel with another resistor, all the current goes through the superconductor! Doesn't matter if the other resistance is very, very low, but still nonzero.
Reportedly some undergrad thought of this.
So the superconducting layer is bonded to stainless steel tape, which is strong, not brittle, and will go down to cyrogenic temperatures without problems. Most previous superconducting "wires" had brittle ceramic insulation, which was hard to wind into magnets.
This is really clever.
Here, since you're using a much higher Tc material, if Tc is lowered by a few K you still have plenty of thermal budget, allowing you to take the hit from the proximity effect but be able to save on insulation.
The article outlines a plate design that incorporates steel/REBCO windings and cooling channels for liquid helium that seems to be modular and easily serviced.
REBCO is actually listed as a high-Tc material in the wiki below, but requires liquid helium.
If this were reworked into a liquid nitrogen design, could it reach 20 Tesla?
https://en.m.wikipedia.org/wiki/High-temperature_superconduc...
https://www.nature.com/articles/s41598-021-81559-z/figures/6