I'm always a fan of bigger numbers, but I wish more time/money/whatever was put into letting DDR5 run at those XMP/EXPO speeds when using 4 DIMMs.
In the past some motherboards tried a T-topology for RAM slots to optimize for 2 DIMMs per channel, but this would cause problems with 1 DIMM per channel usage. Not worth it for the average consumer.
What if you use a similar technology to registered or load-reduced memory, but put the register on the system board instead of the DIMM so it's in front of multiple DIMMs that then share the channel into the processor but not the traces on the system board? This may also allow higher capacity DIMMs in consumer systems.