People break USB ports all of the time, and ruin DisplayPort ports because they’re a locking connector.
Also, USB-C. The combination of video, power and data transfer that any laptop supports is up to the manufacturer, so it’ll fit but will it do what you need?
This is not obvious. Display port's UI is like modern UIs: one cannot tell if the protrusion of the connector can be pressed or not. Also the force necessary is quiet high.
For example: https://www.amazon.com/dp/B0CY3W7PG3
If that’s what you meant, are they center positive or negative? What’s the voltage? What’s the outer diameter? What’s the inner diameter? What current is required?
A known barrel jack for a known device is simple. Have a device and need to replace a power supply? It gets complicated.
The drive was fine once I took it out of the enclosure, fortunately.
The drive was loaned to us for testing by a disk controller company that had hired us to write drivers for their new controller, and they had received the disk on loan from IBM.
It was a 1 gig drive at a time when 200 MB was the norm for a big personal computer disk and not yet on the market. At that stage only a select few outside of IBM had been loaned these drives for testing.
I was pretty freaked out. I assumed that I'd be in a lot of trouble for destroying the drive. I told the person who had loaned us the drive what happened and he told me that he'd fried two of these drives the same way!
He'd found out from his contact at IBM that IBM was losing about 10% of the drives from the early production runs due to their own technicians plugging power in backwards when testing the drives as they came off the line. The contact also said that IBM had already revised the parts list to switch to a Molex connector whose plastic was firm enough to end this problem.