If you mean something like a Nord-Lock washer, then carry on.
Actually, they only perform a tiny fraction of the crucial services performed by washers and can be replaced by loctite in almost all situations, so, I'd contend they are the most worthless of washers.
Given it's more or less impossible to sufficiently torque a wing nut, there are actually not many great solutions...
A dab of low strength loctite would definitely help, but that's one-time-only and you've got to carry the loctite around if you want to re-do the connection... At which point why not just carry a spanner instead and just use a properly-torqued normal nut?
Probably the best would be to swap out the plain wingnuts for nylock wing nuts, which should at least help a bit.
There are very few applications where a split washer adds much value.
Somewhat ironically, greasing threads can actually result in a more reliable fastening as it permits removal of the bolt or screw and permits stronger tightening which can increase the physical bond.
If you really want a reliable fastening, use a retaining device such as a cotter pin or retainer ring, or riveted fastenings ;-)
<https://en.wikipedia.org/wiki/Cotter_(pin)>
<https://en.wikipedia.org/wiki/Split_pin>
<https://en.wikipedia.org/wiki/R-clip>