Thank you so much! I appreciate the advice about the potentially over stylized product pages. If you go to the store here, you can see many full profile views of the products:

https://velofuso.com/store

You raise a ton of good points.

- It's going to ship with a full spare parts catalogue available

- Full prusa-esque upgrade paths will be made available for existing customers

- Every single part on either product can be changed off with the removal of 1-5 screws.

- The switches, cords, buttons, and (gear)motors are all standard sizes.

- and I absolutely commit to open sourcing everything if a day came where the project could not continue (I have done this for previous projects, it isn't an empty promise)

You make a good point about the burrs being a non-standard size. The thing to remember is every size of burr was once a non standard size. One of the most important parts of being a good engineer is only making something new when you can truly add value, and I think the burrs are valuable enough to have them be probably the only non-standard wear item in either machine.