The default should be X / GND / X GND to maintain tight coupling of both signals and power to the GND plane and stitch the GND planes together with vias close to any other via that changes layers to maintain return paths.
Power should be routed normally, except it should use widest practical traces and get decoupled with C close to ICs that consume it.
But in any case, you always need to think about the signal and return. Even for power. It's never truly DC.
If you do the "classic" signals / GND / VDD / signals, you are routing over VDD plane and your ground is waaay farther. Means all accidental VDD noise (you can't pinpoint, because it takes frequency dependent paths across the VDD/GND C) gets coupled into your signals on the back side.
So don't do that.