Many of the instructions have similar mnemonics, such as the conditional branch instructions (BEQ, BNE, BCC, BCS, BMI, BPL, BVS, BVC), as well as the arithmetic instructions like ADC, SBC, EOR.
Many of the instructions have similar mnemonics, such as the conditional branch instructions (BEQ, BNE, BCC, BCS, BMI, BPL, BVS, BVC), as well as the arithmetic instructions like ADC, SBC, EOR.
Not really (perhaps leaving mnemonics aside). The 6502 has little in common with the first ARM. The ARM's designers liked the simplicity and speed of the 6502 and it was their favourite 8-bit ISA. And a visit to the Western Design Center convinced them to design their own CPU.
However, the early RISC papers were the biggest influence on the design of the ARM. There is even a clue in the name 'Acorn RISC Machine'.
They obviously also studied foundational papers on RISC and understood the possibility of having a simple design (such as the 6502, which was very powerful considering its small transistor count) applied to a simple, more regular, instruction set.
Assigning weight to these factors might a futile exercise, as the designers themselves might not agree.
They were not blind to RISC and, therefore, it made sense to put it in the name of the architecture.
But I don't think that ARM 'ARM borrowed most of its design from 6502' or (to my mind at least) looks like a refreshed 6502. There are just too many fundamental differences:
- ARM1 was a load/store architecture / 6502 wasn't.
- 6502 had a few special purpose registers / ARM1 had loads of general purpose registers.
Plus there are lots of key innovations in ARM1 that weren't in either 6502 or RISC 1 such as conditional execution. Furber and Wilson were really quite innovative and didn't just borrrow ideas from other ISAs.
Nobody can ever question that.