It is the 'curious' response.
If you have used zip ties in adverse conditions you would immediately know they suffer from two huge issues, the first is that under stress the ratchet nib can break and they release, the second is that on a strength to volume and strength to weight ratio they are grossly inferior to any number of threads.
So for something you are sending very far away, and for which you have to put 4.3 ounces of launch system together for every ounce you want to land on the surface, mass and volume add up, and you can't really go out and replace a broken one can you?
Overtightening of cable management bindings can cause conductor breakage, insulation damage, excessive chafing, and deformations between the conductive, dielectric, and shield parts of a cable, and no doubt a host of other issues. It is one of the classic problems with ratcheting plastic cable ties (i.e. "zipties") that they only have quantized adjustment steps and cannot be easily loosened. While zipties with a metal tooth insert do allow for smoother tightening, the possibility of this tiny metal part coming loose near electronics generally excludes their use. That zipties cannot easily be loosened or adjusted during tightening makes them more prone to being left in an overtightened state. Difficulty of adjustment might also be considered a possible strike against using the Constrictor Knot (and similar knots) for this application.
An over tightened zip tie can be quickly cut away.
The thing that seems reasonable to me is lacing works for thin cabling, but if you have a fat bundle of cables (say 5mm or more in diameter) I can't really see a big problem for zip ties.
Less of a concern on Mars, but the edge where the excess is cut away can be really sharp and hazardous as well.
A few more points:
- Zip ties are also made of ABS plastic - which has a Tg of <200*F...things start uncoupling around there.
- Kapton gets brittle, and most of these cable bundles are covered in the stuff.
- Mass. There are plenty of lightweight fibers (Aramid/Kevlar, carbonfiber, nanofibers, etc) whose tensile strength is greater than steel.
- Lastly, I'm biased against zip ties after multiple recabling projects while in IT...
It might be that tension (which is what I worry about when I zip tie delicate things like optic fibre) is better controlled in hand tied knots, but zip ties can be tied pretty precisely.
Zip ties are 'quantized' by the ratchet, so you can find an 'optimum' tension point that is between two ratchet points. Which doesn't happen with laces.
And for threads (like kevlar thread) it doesn't have the compression strength to be good zip tie. There is a lot of information about what NASA considers to be good and not good wrapping techinques here: http://workmanship.nasa.gov/lib/insp/2%20books/links/section...
Also they mention out gassing which is something I completely missed, plastic zip ties have that issue as well. Any void in the zip tie also becomes a real problem in vacuum.
A zip tie requires a different combination of compression strength, tensile strength, and elongation stability compared with lacing. So the materials are not interchangeable.
Also, individual fibers bundled into a cable is MUCH MUCH stronger than the exact same amount of material as a single homogeneous cable.
And individual fibers can handle flexing and vibration far far better than a single large strand.
Also arm chair guessing.