When working on a project where you need a bunch of things to be the same, you take a stick and mark on it at various points the dimensions you're using -- when working on a house, it might be things like the heights of outlet boxes and switches, the width and height of rough opening for doors, the height of window sills, etc etc.
Then, you just use the stick as the reference, using the marking for outlets to position all of the outlets instead of measuring the height of the floor in inches or millimeters or cubits or whatever each time. It's kind of like a measuring jig.
("Measure once, cut twice" is a superior methodology which has been unfairly maligned for generations.)
It feels really imprecise the first time you set the fence on a table saw based on a marking on a stick instead of a precise specific value but the results are hard to argue with.
Sure, check your measurements to be sure they're correct, but the more times you can cut based on the same measurement, the less measurement error can creep in.
A similar strategy I've used when I've known that there was going to be cuts that I couldn't sequence like that is to cut "as built" story sticks with scrap dimensional lumber and write what they are right on the board.