http://en.wikipedia.org/wiki/Selective_laser_sintering
http://www.solid-scape.com/products/solidscape-3d-wax-printe...
http://www.contourcrafting.org/
Also, plastic 3D printing is a low-part-order replacement for injection molding, and is significantly cheaper for short-run or prototyping. And it is not designed to be a one-stop solution, but simply part of a workflow that can be brought to small fabrication shops to permit them to construct a wider range of things.
That said, the biggest limitation of the Makerbot series of printers in my opinion is the lack of a soluble support material. The Dimension printers [1] allow you to fabricate models with both a structural plastic (ABS) and a support material (unknown) that will dissolve in a lye bath, meaning you can make complex mechanical components in one pass and then dissolve out the unnecessary sections.