(I'm not sure if there was a way around this, there may well have been but I had other things going on and sold for scrap)
(I'm not sure if there was a way around this, there may well have been but I had other things going on and sold for scrap)
The “Design for purported Safety vs. Design for Saving Dollars” principle at work.
I can almost guarantee the lion's share of this is shop labor, not parts, and pressing a bushing out and back in would be more expensive after accounting for that labor than just swapping the suspension arms. This is often the piece that gets missed in these discussions of "why am I replacing this huge assembly for a tiny part", if the whole assembly is coming out to deal with that tiny part anyways and shop labor is $200/hour it's cheaper to swap the assembly a lot of the time.
Try getting any repair beyond routine maintenance done on a car in the US for under $1000 these days. Car maintenance is one of the things I'm happy to DIY in most cases because the delta on costs is massive and as someone that works on computers all day it's vaguely enjoyable to get angry at a mechanical object for a change.
Really? It's literally a few minutes (a few dozen $ at $200/hr, or $3.33/min) for any shop with a press. Removing the assembly from the rest of the car is going to take much longer.
https://www.rockauto.com/en/catalog/jeep,2012,grand+cherokee...
The worst practices with cars is when they make it too tight or engineered to work on. Ford was kind of notorious for this - some dealers would do cab lifts for routine-ish work to save labor hours. I had a 90s Cadillac that required un-mounting and tipping the engine to change the rear spark plugs, unless you bought a really expensive tool.
I've heard of people (who own a press) simply pressing out the existing bushing and pressing in a new one.
The trick is to get a new one - typically you'd have to press out the existing one, then run around town to find a match.