It covers every use case for high temperatures and more impactful the higher temperature you want. Melting iron using fossil fuels at 1,500 °C also means wasting high temperature exhaust air.
It covers every use case for high temperatures and more impactful the higher temperature you want. Melting iron using fossil fuels at 1,500 °C also means wasting high temperature exhaust air.
https://www.sciencedirect.com/topics/engineering/cowper-stov...
https://en.wikipedia.org/wiki/Air_preheater#Regenerative_air...
Really high efficiency home furnaces require cooling the exhaust gasses low enough for water to condense but that low temperature heat isn’t particularly useful at a smelter where low relatively temperature waste heat is plentiful.
There’s other issues like introducing drag which requires either a large chimney with hot exhaust gasses or fans to force airflow etc.
In the end the only thing that matters for these calculations is relative efficiency where electricity wins by ~20% or so in the real world plus fuel lost in transit.
I suggest you read through the links pfdietz provided, and understand them, because you are mistaken about this point. It is not a peripheral issue; it has been central to thermodynamic machinery since Stirling.
Coal is the only fossil fuel with minimal hydrogen turning O2 into H20. Latent heat of vaporization for water is very high, but you can only extract that by cooling the exhaust gasses below its dew point. Preheating alone doesn’t let you extract that energy from exhaust gasses.
Further for a furnace the transfer is zero sum, remove 1g of water from the exit stream move 1g to the input stream and now there’s an extra gram on the output stream canceling out the transfer.
More fundamentally, current numbers come from what is actually happening not what could in theory be done.
Now, in combustion the gas streams are not identical in composition and mass, so there is some unavoidable loss, but the efficiency gain can be very large. Recuperation had a huge effect on the efficiency of blast furnaces.
Aside from pfdietz's good point about regenerators, resistively melting iron with electricity doesn't require any high-temperature exhaust air.
My point was people natural gas smelting is a long way from the 98% efficiency you see in high end home natural gas heaters. Latent heat of vaporization means it takes far less energy to warm the incoming air than you can extract from the exhaust.
It doesn't.