I've had very few issues using it over the past few months, but since the founders are probably eyeballing this thread I'll lay out some of my suggestions here.
-If I try to export an unsaved circuit, I get a prompt pestering me to save my circuit before exporting it. This happens nearly every time for me since almost all of my circuits are quick no-nonsense stuff that I spend 30 seconds on. I suggest that when I try to export an unsaved circuit, it gets automatically saved to my folder as _exportedCircuit[0/1/2/3/..]. At the very least make the export button bring up the save prompt if I press it with an unsaved circuit.
-The components are a bit of a hassle to navigate. To reach any one component, I have to do loads of scrolling through that menu on the side. Often I'm looking for a component, get halfway to the bottom, and wonder if I had missed it. It would probably be better to implement the component box with the components of each category nested under a category button.
-Virtually all of my exported circuits are going into a word document. The first time I did an export I had to measure how wide my word document was in pixels so I could get a full resolution image on it without going over the pagelimits. I suggest implementing an alternate export size field for exporting the image in terms of width/height in inches of a standard word document.