But of course, the people that burn their speakers this way don't care about dynamics or evidently about sound quality if they press their computer speakers like this. Can't sound not even a little good.
But of course, the people that burn their speakers this way don't care about dynamics or evidently about sound quality if they press their computer speakers like this. Can't sound not even a little good.
And they should be built to be able to withstand any valid signal.
They are still terrible speakers, though. I almost laughed when showing a friend Star Wars for the first time; it doesn't even come close to doing the soundtrack justice.
External DVD Drive, play one of my DVDs on the Mac, audio is perfectly fine.
Play the same DVD on my Asus UX31, cannot hear the people talking, use VLC player to up the audio to 125% and its fine.
On the second, the screen began to go at 14 months. I would never by consumer electronics from Dell again.
Speakers/amps should have DC protection builtin.
Limiters cannot either distinguish or protect against the technical difference between a sine wave and a square wave:
http://i.imgur.com/oE5NFZ9.png
The red trace is a normal audio signal that doesn't exceed the dynamic range of the amplifier. The green trace is an example of the kind of signal one gets by turning the volume up way above normal.
In a hypothetical speaker of one ohm and a peak voltage of one volt, the red trace has a time-averaged power level of 1/2 watt. The green trace has a power level of one watt -- twice as high, and possibly too high for the speakers to tolerate.
> Speakers/amps should have DC protection builtin.
This example should show that this isn't possible without taking the temperature of the speaker's activation coil -- and even that might not work.
Yes in principle, but it would be rather complicated -- it would need to have its own microprocessor just to save the speaker. D/A ICs with included amplifiers are already pretty complex. Also, if a user was listening to music that had an occasional high level, the special limiter might kick in and spoil the sound of the audio for a transient that wouldn't actually jeopardize the speakers.
IMHO everyone who is saying "this should be fixed by software" is doing it wrong. How much would it cost to write, test, debug, etc. the appropriate firmware/drivers? And it would still be subject to "warranty is void because you didn't use the right software". That cost could buy a lot of capacitors... and then if the values were chosen correctly, whatever the software does, it would not be able to put more power through the speaker than designed.