Let's put it this way: if you have high gain metal distortion circuit gained up to a 5mV clipping threshold, and then you roll down your guitar volume knob to play the blues, you're kinda using it wrong.
Let's put it this way: if you have high gain metal distortion circuit gained up to a 5mV clipping threshold, and then you roll down your guitar volume knob to play the blues, you're kinda using it wrong.
The point still stands that you can get the distortion effect, at the desired amount, at various places in the signal chain.
The problem you're talking about is about using too weak a signal and then using make-up gain. That can also happen anywhere in the chain.
I can reproduce the problem without distortion at all, using a clean signal chain.
Repro 1: turn down the guitar volume to simulate an extremely weak pickup. Then turn up the input gain to compensate. Result: noticeable increase in noise.
Repro 2: turn down pre-amp volume, and crank up power amplifier volume to compensate. Result: noticeable increase in noise.
Gains/levels have to be evenly distributed in the chain.
Sure, you will lose headroom if your intent is to have some soft distortion from the back-end of the amplifier, but you put a heavier distortion earlier in the signal chain. The heavy distortion masks the later one; it evens out the level so the headroom from the back is not available. There is a fix for that: you can punch that distortion in and out with your foot as needed.