- avoid noise early on in the change
- turn your guitar up halfway
If you want to avoid noise early in the gain chain, do not rob your guitar of signal by attenuating the output of the pickups with the guitar's volume. Now though that is done, by some players (and works for them), it isn't a way to get headroom or minimize noise.
You get the least amount of noise by keeping the volume of the guitar at maximum, and switching tones later in the chain. A clean pre-amp channel has much better noise characteristics than a dirty channel, and rolled down guitar volume control.
Seems like the bad noise in the case we're discussing would be what the tube circuit generated when it was not being intentionally driven to distortion... is that a correct interpretation?
Frequency components that are not in the original signal, but are only present when the signal is there are usually distortion.
(Why "usually": radio-frequency interference is noise. In audio, you may not notice RF when there is no signal. But when signal is present, it may mix with RF in a nonlinear way, causing additional distortion products attributable to the RF. I.e. the RF noise is "descends" into the signal's frequency range via intermodulation.)