...? I've always driven that way, except when I was practicing on a stick shift (which I did not like, because it had more pedals than I have feet).
Do people seriously not like doing this for some reason?
...? I've always driven that way, except when I was practicing on a stick shift (which I did not like, because it had more pedals than I have feet).
Do people seriously not like doing this for some reason?
When I was taking Drivers Education (way back when) my teach asserted that from a neurological perspective it was faster for the brain to use one foot than two, because using two introduced an additional step in the process of deciding which part of the body to active. His claim (and I don't recall him providing direct evidence of this) that having go/stop be a choice of two movements of a single limb, allowed you to react faster than picking which of two limbs to activate for the desired behavior.
Good luck finding a stick shift if you don't custom order it these days, btw
So people's left foots were not sensitive enough for the break. Whereas the right foot was trained on the soft accelerator.
As a stick shift driver, it took me years to learn left-foot braking without stomping on the break and coming to an immediate full stop. But left-foot braking comes in very very handy on snow and gravel. It's also a lot of fun.
PS: modern clutches are soft, but you still usually either depress it fully or leave it alone, which means your left foot isn't too well trained in applying varied degrees of pressure
Edit: after doing some reading it seems this only happens when you aren't using the clutch, which means it makes left foot braking impossible.
Yes, the author and proponent of this method of driving neglect this point entirely, and that it is clearly more dangerous (for the following drivers) to drive with "broken" brake lights.
But perhaps he believes that this habit could be broken as well?
I do know of a 3-pedal scenario, though--on an uphill stop, maybe a traffic light, when another car gets close enough to you that you cannot afford to roll backwards. If you haven't planned for the situation (by using the clutch to maintain position rather than the brake), you'll need to continue braking while you start the car moving forward, to prevent rolling back.
I was taught to approach target position on hill, disengage gear train, use brake to hold car. Then, quickly switch from brake to clutch while applying gas... That's tough too.
So I always used the hand brake, leaving my two feet ready to use clutch and gas. In that case, it's optimal. Apply clutch and gas, until car begins to want to move, release hand brake and continue.
I won't own a manual car lacking a hand brake for this cuse case alone.
Now, with skill, it's entirely possible to do this with just the three pedals. One needs to release the brake, and while moving the foot to the clutch, engage gas and very rapidly find the engage point of the clutch and then continue to get the car into motion from there.
Roll back on this is perhaps an inch or maybe two done well.
I can do it, and was made to practice this, but I don't like doing it at all as it requires one to really execute a few things quickly with good precision.
I can do the hill thing without rolling back in a car I'm familiar with, if the hill is not overly steep. Basically I hit the engage point while still depressing the brake. If the hill is too steep, you can stall doing this.
Anyway, I realize it's bad to use your clutch that way, but it seems better than rolling into a car, in most cases.
I can release the brake and engage clutch quickly enough in a car I have driven to avoid a significant roll. There is always the hand brake too.
I never replace clutches either. In most cases replacement is not too expensive, so whatever works right?
I was explicitly taught not to do this as well, and I've seen it go bad in action too. In many cars, slamming both pedals down hard results in the car continuing to move, when it's usually desirable for the car to quit moving more than it is for the car to speed up.