In order to get accurate timestamps, processing midi IN takes priority over OUT.
So OUT can vary in latency between 5ms and 60ms. An unfortunate amount.
Improvements can be made here. I'd recommend a splitter if you need low latency.
612 karma · joined November 5, 2018
In order to get accurate timestamps, processing midi IN takes priority over OUT.
So OUT can vary in latency between 5ms and 60ms. An unfortunate amount.
Improvements can be made here. I'd recommend a splitter if you need low latency.
seems hard to fake that. and you could randomly quiz them on it .
btw check out http://reddit.com/r/jamcorder for ongoing discussions.
Up until now I've only known of some DAWs & custom raspberry-pi like solutions.
Though the Fantom X6, you have to push 'record' afterwards. Still cool, though!
Thanks for sharing!
thanks for your thoughts, I'll add midi out playback :)
and yes, head deep in midi knowledge by now but that is a good point about hanging notes.
All midi messages are captured, on all 16 channels.
modern ESP-IDF: https://github.com/espressif/esp-idf/pull/12566
versus 3 years ago: https://github.com/chipweinberger/xesp-usbh
> I am not sure if it will work in 10 years.
This was a big concern of mine too. That's why as much of Jamcorder as possible is open standards.
There is also a local web interface, http://jamcorder.local, that is fully extensible by the user. And the BLE and Wifi APIs are not locked down. You can implement your own app.
The biggest limiting factor IMO, are Wifi and BLE still going to be in common use in 30 years? That's hard to predict. But the SD card will still be there. Its a tough problem.
I think that's about as good as you can do, short of putting a screen on it.
----
There's even a feature identical UART interface for the device. Surely that will still work in 30 years.
But definitely not humanly noticeable.
And if you choose, you can make it slightly harder to invoke by requiring an additional 'function' note to be held down.
I haven't felt need for a bookmark button in the app yet, but it did cross my mind.
In theory it should be fixable now.
It also has an open API, that's pretty simple. So you could integrate it into other apps or open source software.
I'll add you when I create one.
Appreciate the interest :)
For the firmware, I would have gone with Linux + a higher level language, probably Golang, because my iteration loop was almost 2 minutes w/ C & esp32. Way too long.
But at least it made the product very power efficient, and a bit cheaper.
Btw, you should follow the hot reload thread on Github for ESP-IDF: https://github.com/espressif/esp-idf/issues/12642
just remeasured it to double check.
Yes there are some limited times you might want to turn off recording. I've given this some thought. For now, unplugging is the simple answer.
Should be pretty straightforward! I'd want a decent UI for it!
Yes I have a lot to share about the production process. Blog posts are planned! It was quite fun!
So if the synth supports MIDI CC, the settings would be 'replayed' :)